Unfortunately since the VForce2 was discontinued long ago, we no longer offer instructions for the VForce2. However as we know there are still some users out there, we want to make sure those users know how to use the adjustable reed stops.
The most important thing to remember is to avoid over tightening the screws holding the reed stops, if you choose to make any adjustments. You simply want to snug them up. If you over tighten them you will strip out the composite cage.
The adjustments are as follows below…
High Tension setting: Reed stop is rolled back towards the manifold plate. This creates more pressure on the reed petal and creates a higher tension petal which aids in top end gains.
Low Tension setting: Reed stop is rolled forwards towards the reed tips. This creates less pressure on the reed petal and creates a lower tension petal which aids in bottom end gains.